This Scania G480 came into service at Ilpo Lehtinen Oy from Nurmijärvi (FI) in 2009. This nice looking crane-truck was built by Tyllis Oy from Kokkola (FI).

The tractor is a Scania G480 in 8x4 version. It has the medium-hight Highline cab.

Tyllis installed the Fassi 1300 at this chassis. They also reinforced the chassis to the front so that the crane can also be used over the cab.

It is a Fassi F1300AXP.26 meaning it extends 6x hydraulically to 15,5 meter where it can still lift almost 5,5 tonnes. At 4,1 meter it can lift it's maximum load of 22 tonnes. Interesting is that it doesn't have a winch.

The Scania pulls a 3-axled Krone semi-lowloader with a liftable rear axle.

The tractor can also be used as a normal truck. The demountable floor is connected at the front with 2 rods that go into the holes below the yellow toolboxes. The other side of the floor supports on 2 ball-heads at the side of the chassis.

The 6x hydraulic extendable jib gives a total outreach of 27,55 meter. The crane can lift 1435 kg at that distance. The support frame lowers a few centimeters just before the fifth wheel to reduce the connection-height.

A very nice crane truck, not only the styling, also the technical side!